Hello,
I have a ping pong serve machine that has control that can adjust the serve. There are four different elements that can be adjusted, each element has two buttons an increase and decrease button to adjust the level(0-9) of the element.
I want to use the raspberry pi to be able to click on the buttons programmatically, so I don't have to click on them physically. What would be the best way to do this with the GPIO pins, and what should I be careful of as not to damage the raspberry pi or the serve machine.
I've attached below a picture of the inside of the controller, thanks in advance for your help!
I have a ping pong serve machine that has control that can adjust the serve. There are four different elements that can be adjusted, each element has two buttons an increase and decrease button to adjust the level(0-9) of the element.
I want to use the raspberry pi to be able to click on the buttons programmatically, so I don't have to click on them physically. What would be the best way to do this with the GPIO pins, and what should I be careful of as not to damage the raspberry pi or the serve machine.
I've attached below a picture of the inside of the controller, thanks in advance for your help!
Statistics: Posted by motasem — Thu Apr 18, 2024 10:01 pm