Networking and servers • Re: How to set correct Ethernet NIC

Code:

Settings for enx002427882917:        Supported ports: [ TP    MII ]        Supported link modes:   10baseT/Half 10baseT/Full                                100baseT/Half 100baseT/Full                                1000baseT/Half 1000baseT/Full                                2500baseT/Full        Supported pause frame use: No        Supports auto-negotiation: Yes        Supported FEC modes: Not reported        Advertised link modes:  10baseT/Half 10baseT/Full                                100baseT/Half 100baseT/Full                                1000baseT/Full                                2500baseT/Full        Advertised pause frame use: No        Advertised auto-negotiation: Yes        Advertised FEC modes: Not reported        Link partner advertised link modes:  10baseT/Half 10baseT/Full                                             100baseT/Half 100baseT/Full                                             1000baseT/Half 1000baseT/Full                                             2500baseT/Full        Link partner advertised pause frame use: Symmetric Receive-only        Link partner advertised auto-negotiation: Yes        Link partner advertised FEC modes: Not reported        Speed: 2500Mb/s        Duplex: Full        Auto-negotiation: on        Port: MII        PHYAD: 32        Transceiver: internal        Supports Wake-on: pumbg        Wake-on: g        Current message level: 0x00007fff (32767)                               drv probe link timer ifdown ifup rx_err tx_err tx_queued intr tx_done rx_status pktdata hw wol        Link detected: yes