Hello All. New to the Pico and new to the forum.
I have a simple program which lights up a WS2512B Neopixel strip one direction when one of the touch sensors is pressed and lights up the strip from the other direction when the other touch sensor is pressed. The rest of the time I would like the Pico to go Dormant however I am no longer sure that is even possible. I would also like the Pico to be able to monitor it's battery health and flash a different sequence when the battery is low. I purchased the Pico because I understood that both of these cases were possible.
My question is can I put the Pico in a low power state and wake the Pico using only the two GPIO pins mentioned above and which IDE/language would be best to accomplish this task?
Thank in advance,
n
I have a simple program which lights up a WS2512B Neopixel strip one direction when one of the touch sensors is pressed and lights up the strip from the other direction when the other touch sensor is pressed. The rest of the time I would like the Pico to go Dormant however I am no longer sure that is even possible. I would also like the Pico to be able to monitor it's battery health and flash a different sequence when the battery is low. I purchased the Pico because I understood that both of these cases were possible.
My question is can I put the Pico in a low power state and wake the Pico using only the two GPIO pins mentioned above and which IDE/language would be best to accomplish this task?
Thank in advance,
n
Statistics: Posted by nullset — Sat Dec 23, 2023 11:44 pm